Then I started testing and setting all the CV's.
Had a problem in that the smoke unit stayed on permanently.

I checked and rechecked my work, a few times using my multimeter and check
all connections for shorts to any others and everything showed up perfect.
So I studied the ESU decoder instructions a bit more, there are so many CV's to adjust
and set up its scary.
This morning I found my ESU decoder tester and immediately connected that up and plugged
in the decoder.
Well here it worked correctly and I could switch F 1 on and off as I pleased.
So the problem had to be in the loco.
Dismantled it again and rechecked every connection and solder joint with a magnifying glass.
Ah, I found a tiny solder blob between two solder pads.

Removed that and everything is perfect.

Fitted a 2200µf cap and but everything back together.
Stay tuned for the next project.
