Good day dear train friends,
Small update. Wanted to make a fence but a little bit different. You can not have the same one everywhere.

So I made a little jig to drill the holes in the same area of each match "post". I had to make about 70 and had to start up a small production line.
A slant was cut on top of the post so that the rain water can run off.
All the holes were drilled with the Dremel and then painted a dark brown. And that was a mistake.

Hot Tip! First paint and then drill the holes for the wire. I realized that when I wanted to thread the wire through the posts.

I had to open up each hole and there were approx 140 of them.

Once the holes were open again I threaded the wire through the holes. Boy that was fun. Took about 2 hours.

I think the pics will tell the story.
Best regards until next time.

Ciao
ColWer